Original GoolRC TG3 Digital Radio Remote Control Transmitter with Receiver for RC Car Boat

Yes. You can adjust sub trim left and right as well as throttle trim and fine tune sensitivity

By Lola on May 13, 2018

This is a 2.4ghz it comes with its own reciver so the old radio system and reciver is no longer needed

By 83cj7jeeper on May 8, 2018

Take the receiver and remove it from your vehicle. Next, turn the transmitter over and slide off the battery door. Remove the installed batteries and put them somewhere safe. Take the receiver and place it in the battery compartment and replace the door. Take your new assembly and throw it in the garbage where it belon… see more Take the receiver and remove it from your vehicle. Next, turn the transmitter over and slide off the battery door. Remove the installed batteries and put them somewhere safe. Take the receiver and place it in the battery compartment and replace the door. Take your new assembly and throw it in the garbage where it belongs and order a new TX/RX combo. These consistently lose signal, jitter, studder, and randomly peg out inputs. I swapped in an Axial combo to see if it was my ESC or Servo. It wasn't. see less

By D. J. Quintero on May 3, 2018

If you are talking about a real skateboard, I would not recommend it. A small RC skateboard, sure with the right components.

By Larry on April 30, 2018

I would not recommend it.

By Larry on April 15, 2018

I love mine. It's inexpensive but works great. I really like the 3 way throttle setting (LMH) for when I'm crawling. I bought one and then some spare receivers since they are so easy to bind. It's lightweight but doesn't feel cheap. Good feel to the grip and wheel. Throttle and Steering trim. Steering rate. And agai… see more I love mine. It's inexpensive but works great. I really like the 3 way throttle setting (LMH) for when I'm crawling. I bought one and then some spare receivers since they are so easy to bind. It's lightweight but doesn't feel cheap. Good feel to the grip and wheel. Throttle and Steering trim. Steering rate. And again, a LMH setting for the throttle. It's nice on my D90 to slow it down so I don't do wheelies when I'm crawling with it. I use this for my Orlandoo Jeep and my 1/10 D90. Channel 3 is only a push-button so 2 Settings (full left, full right on a servo), not good for a winch. see less

By Charles on March 22, 2018

The reciever included with this radio is a micro rx so yes it will fit the rx box on the stampede as well as most other rx boxes.

By leonardo rosiles-cervantes on March 11, 2018

Near as i can tell 3rd channel works for winch. I could be wrong, sorry if i am

By glenn ahrensfeld on March 1, 2018

Yes, and it is already bound to the receiver it comes with.

By Larry on February 21, 2018

The receiver isn't connected directly to the power source, it's powered by the esc. But still this radio is no good, if u burn out the receiver you can't buy replacement.

By leonardo rosiles-cervantes on February 21, 2018