Mouse over to zoom in
28.46
DIY Kit Thermoelectric Peltier Cooler Refrigeration Cooling System Heat Sink Conduction Module + 2 Fans + 2 TEC1-12706
Price:
US$
28.46
Loading...
Ship to
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Questions & Answers
Yes you can. If you flip over the 2 Peltier coolers, then the heat sink on both sides will get cold and the water will get warm.
By William A Mello on May 17, 2018
I don't know if you can find a solar panel and output controller that will work reliably with the thermoelectric cooler and fans. The coolers operate at anything above 4 volts. I'm using it to cool 0.5 gallons of vacuum pump oil. I don't know the ultimate temp I will get. I don't know what the nature of the volume … see more I don't know if you can find a solar panel and output controller that will work reliably with the thermoelectric cooler and fans. The coolers operate at anything above 4 volts. I'm using it to cool 0.5 gallons of vacuum pump oil. I don't know the ultimate temp I will get. I don't know what the nature of the volume is you want to cool. You'll need to do some experimenting. see less
By Bart Cannon on February 27, 2018
This water inlet and outlet are barbed and sized for clear plastic water tubing with inside diameter of 1/4” (8mm) and will probably have an outside diameter of 3/8”. This is not to be confused with water tubing for compression fittings which is also “1/4 inch tubing” but has 1/4” OUTSIDE diameter. … see more This water inlet and outlet are barbed and sized for clear plastic water tubing with inside diameter of 1/4” (8mm) and will probably have an outside diameter of 3/8”. This is not to be confused with water tubing for compression fittings which is also “1/4 inch tubing” but has 1/4” OUTSIDE diameter. Interesting design note: 1/4 (outside diameter) water tubing fits snuggly inside 1/4 (inside diameter) clear tubing allowing you to transition to compression fittings based water systems. see less
By Dale H on July 7, 2018
Discussions
Please note that TOMTOP Forums are a community for all communicating and getting help each other. There will be some enthusiastic friends participate in your discussions. Of course TOMTOP customer service (with tomtop customer service icon) response is guaranteed ,which is the same way you contact us at http://www.tomtop.com/contacts
open this forum in full pageAverage Rating:
4.8based on 8 Customer Reviews
Share your thoughts with other customers and get Tomtop Points, the first 5 reviews get DOUBLE Tomtop Points!
Write a Customer ReviewBy p***a
April 11, 2021
By j***f
April 12, 2021
By d***n
June 19, 2021
By g***f
June 18, 2021
By a***x
April 7, 2021
By w***s
April 6, 2021
By Alex Davis
November 16, 2017
This kit is well thought out. If you are using a high powered PSU, you will want to experiment with the amount of power you are giving the TEC because with these heatsinks, you will not be getting the optimal heat exchange from the hot side, so the middle will not cool down that much and the heatsinks will get very hot. I experimented and found that about 65% power applied from my PSU was getting the cooling block to a good temperature. If you accidentally install the TEC backwards and don't want to fuss with getting it back together in the right order, simply reverse the polarity of the TEC and you will reverse the hot side of the chip.
By penNameAlpha
September 10, 2017
