This remote control shutter cale is specially designed for Panasonic GH4 GH3 FPV photography
Small size, stable, safety and high efficiency
The cable outputs stop, focusing, takingn pictutes signal for remote control 3 sections switch channel, realizing the remote control to GH4 GH3 camera, start / stop the video tapingConnection method:
The corresponding control end and receiver channels on the shutter line connection and good gear switch is arranged on the remote trip. (three section switch settings: the file < 1.3ms, mid-range around 1.5ms, the file > 1.7ms the most remote can not set), will plug the shutter line into the camera shutter control hole, in this process, to ensure that has shut down the camera.A single trigger mode:
This model designed specifically for the video, because GH3 GH4 does not support, camera shutter line switching photographic and video mode, so only through the camera on a dial to switch the shooting mode, to use the remote control shutter control video function, please dial dial to the video camera gear, using the remote control, the three gear switch to on the upside, then dial to mid-range, triggering a camera shutter, started the implementation of the video, and then perform a cycle trigger shutter, stop the video,.
In this process, the shutter line is not a simple triggering the shutter, but first focus, press the shutter operation executed after a brief delay.
The next file, not the implementation of shutter operation, focus.
In this kind of trigger mode, if the dial in the photographic archives, the camera then each toggle switch with three gear a cycle, according to a photo, because this model is particularly suitable for recording operation.Continuous trigger mode:
This mode is specifically designed for taking pictures, in this mode, the file is continuous shooting, the next file is a single photo, mid-range is stop. Decomposition action every photo shoot is in turn the focusing delay - > > shutter, and similar products on the market is only the savage shutter operation, not to focus sufficient delay may cause photographs of fuzzy.Mode selection:
How to enter the trigger mode single or continuous trigger mode? The receiver is connected the shutter release when the power is on, the three-way switch on the remote location determines the shutter line electric after the implementation of that model.
When the receiver is powered on, the three-way switch is located in the mid-range, shutter line after the start, performing a single trigger mode, otherwise, executing continuous trigger mode.Note:
The corresponding 3-gear switch some of the remote controller is the channel may need to be opposite rudder set, can explain and above operating method in the same.
Package size: 10 * 10 * 2cm / 4 * 4 * 0.8 in
Package weight: 13 g / 0.5 ozPackage list:
1 * FPV Multirotor Remote Control Shutter Release Cable