Price:
US$
14.99
Loading...
Ship to
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Questions & Answers
Discussions
Please note that TOMTOP Forums are a community for all communicating and getting help each other. There will be some enthusiastic friends participate in your discussions. Of course TOMTOP customer service (with tomtop customer service icon) response is guaranteed ,which is the same way you contact us at http://www.tomtop.com/contacts
open this forum in full pageAverage Rating:
4.8based on 10 Customer Reviews
Share your thoughts with other customers and get Tomtop Points, the first 5 reviews get DOUBLE Tomtop Points!
Write a Customer ReviewBy d***.
September 29, 2021
By l***r
September 27, 2021
I have a ender 5 pro with updated 4.2.7 silent 32 bit board. It was very easy to install this BLTouch as it has a 5 pin connector that fits right on to the board. I preferred to watch a youtube video on how to set the Z off, lots of videos to pick from. Makes printing easier.
By k***n
September 22, 2021
By j***a
September 17, 2021
It does exactley as it says, was not hard to install and really works. Just keep in mind that the bed has to be leveled manually before using. As I found out setting the Z offset is a little challenging to set but with patience and carefulness it is not that hard to do or cause other problems.My prints are turning out better.
By j***.
September 17, 2021
Works well for me. Install was easy, but my printer is already heavily modded and the issues I experienced were related to the mods I have installed. If this was a stock printer I wouldn't have had any issues and could have just used Creality OTS firmware. But it fixed my main complaint with my printer so I'm happy. Don't attempt this upgrade unless you have a pretty good understanding of how your printer works and are willing to troubleshoot.
By s***t
September 17, 2021
By m***n
September 14, 2021
It is very hard to find products that actually work on my Ender 3 V2. Plugged right in, watched a single youtube video and it was up and running in an hour or two. Would like to find a different firmware because it has its issues, but I have not needed to level my bed since I bought it.
By f***n
September 13, 2021
This solved the recurring need for bed leveling on my Ender 3 Max, making life a lot simpler. No more prints detaching from the build plate because of bad first layer. This BL Touch kit was very easy to install, as the correct bracket was included (3 different brackets for different printers), and the plug was ready to plug directly into the dedicated contact on the 32 bit mainboard. I did thoroughly check if I had to do any adjustments to the wiring as for many other BL Touch kits, but no, everything was just plug and play.
By e***e
September 13, 2021
By c***l
September 11, 2021
Works well for me. Install was easy, but my printer is already heavily modded and the issues I experienced were related to the mods I have installed. If this was a stock printer I wouldn't have had any issues and could have just used Creality OTS firmware. But it fixed my main complaint with my printer so I'm happy. Don't attempt this upgrade unless you have a pretty good understanding of how your printer works and are willing to troubleshoot.
Top Sellers More>
OUR SITE RUNS OF COOKIES