GoolRC A2212 1000KV Brushless Motor w/30A Brushless ESC and Pair 1045 Propeller for DJI F450 F550 Quadcopter FPV Part(A2212 1000KV Brushless Motor,30A Brushless ESC,1045 Propeller)

I have a 3 cell lipo, with 4 of these same 1000kv motors with 1045 propellers. I get about 900g of lifting thrust per motor.

By Joshua B. on March 2, 2018

Have you tried swapping the 3 wires around from the ESC to the motors? If there not connected correctly they will not work, however, it shouldn't cause any damage if connected incorrectly so try any combination of the wires until it works. Additionally make sure to calabrate the ESC's.

By Shannon L. Plesh on January 21, 2018

According to the specs for this motor the rating is 150 watts which requires at least an 18 amp esc controller. The recommendation is for a 25 or 30 amp esc with 9x4.7 or 10x5 props.

By Keith on January 7, 2018

It can if you program it but it doesn't come programmed that way from the factory

By Jennifer on November 1, 2017

This is basically the same ecs. It worked for me. http://www.hobbywing.com/uploadfiles/sx/file/manual/HW-01-V4.pdf

By Trucker57 on October 17, 2017

Go to hardware store, and figure it out.

By Tired of lazy people on October 6, 2017

Yes. This ESC does supply the receiver with power. The power is supplied via the RC/servo connector, which can be plugged into the receiver. Not all ESCs can provide power to the reciever, but it is common. Usually ESCs with this ability will also say they have a BEC (Battery Eliminator Circuit), which is an imprecise … see more Yes. This ESC does supply the receiver with power. The power is supplied via the RC/servo connector, which can be plugged into the receiver. Not all ESCs can provide power to the reciever, but it is common. Usually ESCs with this ability will also say they have a BEC (Battery Eliminator Circuit), which is an imprecise term, meaning instead of using one battery for the ESC and another battery for the RC hardware, the battery for the RC hardware is "eliminated". see less

By Nydia on September 17, 2017

It uses a 10" dia. 4.5 " pitch prop

By Gary R. Thompson on September 12, 2017

Trial and erro . Just keep mixing them till one combo works

By jon on August 31, 2017

The Rx is not dependent on the motor. Same goes for servos. You do have to match the Rx to the Tx though. What exactly are you trying to do?

By Trucker57 on July 3, 2017