Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Q & A
no it does not
By robert m lane on June 10, 2017
That's not in the manual. At the low end, they give you three numbers. Range: 20.00 A Resolution: 0.01 A… see more That's not in the manual. At the low end, they give you three numbers. Range: 20.00 A Resolution: 0.01 A Accuracy: +/- [2.0% + 5] I take that to imply the range is 0.01-20.00 A. see less
By Jim, MD, USA on February 1, 2018
No, the probes are used to measure voltage. You must use the "clamp" feature to surround the wire you want to measure the current flowing through.
By alex on August 2, 2017
True RMS: The RMS value is the effective value of a varying voltage or current. It is the equivalent steady DC (constant) value which gives the same effect. For example, a lamp connected to a 6V RMS AC supply will shine with the same brightness when connected to a steady 6V DC supply.
By Electronnix SELLER on April 11, 2018
I do not know about that. have not used it on D C only A C have no complainants with the V O M
By Lewis F Warren on April 9, 2018
Sorry , this is a AC meter only, if you need check DC on auto,please use Tekpower meter, check it on by search Tekpower...DC Clamp meter
By Electronnix SELLER on April 10, 2018
The 202A is an auto ranging multimeter. The only manual settings are in the diode test under the Ohm setting on the thumbwheel.
By M. Ercolino on March 9, 2018
AMPS One wire at a time.
By Amazon Customer on March 3, 2018
Yes. Turn the selector to the ohm symbol, and then you can press the 'Select' button to cycle it to diode check and continuity tester.
By Jake Smith on December 27, 2017
Ok, that answer previously given is incorrect. The question is about reading INSULATION on a meter. That answer is base on fining shorts, and current flow. This meter can't help you with your INSULATION reading, you would have to use a MEGGA meter for that.
By Chase 32 on December 16, 2017
に基づいて 11 お客様の評価
November 23, 2017
October 23, 2017
By Senior Senor
September 26, 2017
August 26, 2017
By M. Magyar
August 8, 2017
By b mac
July 20, 2017
June 17, 2017
September 27, 2016
By Michael F Morris
September 21, 2016
I purchased this to check whether I had a dryer that was going out or a bad breaker. It worked fine and I was able to save the money on a new dryer as the amp clamp showed that the dryer was not pulling an excessive amount of current when the breaker shut off. It certainly isn't a high end device but for the money is a good bargain for routine troubleshooting.
January 28, 2016
July 17, 2015