Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Q & A
also the small cable that hooks to your receiver/distribution board is the +,-, signal that would be black for neg, red for positive, and yellow or white for signal
By Gary C. on July 3, 2017
depend on what brain you are using ion you used a cc3 it will get calibrated on the computer as you do the set up if you want to calibrate the esc by it self you can do it with the radio or they sell a calibration small board and they can be calibrated with that.
By Al on May 9, 2018
Quad copter or plane are virtually the same application.
By Richard Baerlin on April 11, 2018
If you are talking about a flight controller i would get the KK2.1.5. It is easy to setup and you don't have to worry about cutting the BEC cable.
By Amazon Customer on April 5, 2018
yes. it's . I bought ones and functions very well. in this time I'm flying with they.
By carlos navas on March 28, 2018
By Ok on January 2, 2018
Manufacturer suggests 2-3s. Going higher than 3s could result in damage. They work well for me with 5200 20C 3s Lipos. As long as they all work out of the box and are calibrated correctly, you can't beat the price.
By mcwdes on December 31, 2017
The flight controller couldn't care less about your speed controls but your motors do.
By Donald Smith on December 18, 2017
Sorry I don't know. I bought them more for price than the firmware knowledge. They work fine though. Getting some more.
By Jason R. on October 23, 2017
I have a -KK2.1.5 with 980kv motors & a Naze32 full with 1100kv motors and both run fine so you should have no problem your CC3D controller. Most CC3D users are 250 mini racer fans if this your choice then the 30 amp may be overkill and over weight .
By Donald Smith on September 25, 2017
に基づいて 51 お客様の評価
October 6, 2017
May 18, 2017
May 1, 2017
January 18, 2016
January 10, 2016
December 18, 2015
October 3, 2015
October 1, 2015
September 30, 2015
September 12, 2015
September 9, 2015
September 7, 2015
May 7, 2015
March 31, 2015
March 19, 2015
March 6, 2015
February 24, 2015
January 24, 2015
January 18, 2015
January 14, 2015