Precio únicamente en la APP.:
Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Preguntas y respuestas
Los foros de TOMTOP son una comunidad para comunicarse y ayudarse mutuamente. Habrá amigos entusiastas participando en tus discusiones. Desde luego, la respuesta del servicio de atención a clientes de TOMTOP (con el ícono de servicio de atención a clientes de TOMTOP) está garantizada que es la misma vía por la cual no contactarías en http://www.tomtop.com/contactsabrir este foro en página completa
Basado en 12 Reseñas de clientes
Comparte tu opinión con otros clientes y obtén puntos Tomtop, las primeras 5 reseñas obtienen el DOBLE de puntos TomtopEscribir una reseña
By T. Bonini
October 13, 2016
The fuse box has two input feeds with 4 circuits on each side. This not only divides the load, it also gives it the ability to put 4 on battery and 4 on a switched line such as acc or ignition. I put 4 on battery and used a relay to switch the other 4 on and off based on key position. The only down side is the pre-printed labels on the front cover since in my case, they have nothing to do with what I am using it for. It would have been much better to either leave it blank or provide a sheet of labels of common circuits to allow the installer (me) to label the fuses properly.
By Rey d.
December 30, 2017
December 13, 2017
By Adam Sean Olgin
December 6, 2017
December 6, 2017
By Scott A Frum
November 27, 2017
May 6, 2017
worked as expected, could use longer wires on the power in side. I would recommend this for additional wiring, I run amber strobe light, 60" led, 13"led, winch and radio from it and have no problems. My riding buddy's are going to purchase them also. Great product and price.
April 14, 2017
October 24, 2016
October 20, 2016
October 15, 2016
For less than $10 and not having to assemble it myself, this was a very good buy for adding fuses for auxiliary electronics without having to hack apart the factory wiring harness to do so. Very easy to add a constant-on and switched-on set of accessories, with the two input channels. The cover is difficult to remove, and the terminals are somewhat loose. I laid a bead of insulating silicone caulk in the back, which stabilized the terminals, as well as adding some sealant against oxidation
December 21, 2015
Evento popular Más
Lo más vendido Más
Tu pregunta ha sido correctamente enviada
Por favor activa tu cuenta para comprar, de ser necesario, volveremos a enviar un correo para completar el registro.