Favoritos

Passe o mouse sobre a imagem para ampliar

Óleo digital temperatura Temp bitola com Sensor para Auto carro 52mm 2 in LCD 40 ~ 150 graus Celsius grau aviso luz negra

Óleo digital temperatura Temp bitola com Sensor para Auto carro 52mm 2 in LCD 40 ~ 150 graus Celsius grau aviso luz negra

Preço apenas no APP:

Já teve TOMTOP APP

Digitalize o código do produto para comprar diretamente!

Nota: Atualize a APP de TOMTOP para a versão mais recente.

Não tem TOMTOP APP

Faça o download gratuitamente e aproveite as ofertas extras!

Envio de:
  • Armazém de China
  • Armazém de Estados Unidos
Selecione um armazém
Despachar:
Geralmente será enviado em dias úteis horas
Envio:
O pedido falhou! Por favor, tente novamente.
Desculpe, parece que não existem métodos de envio disponíveis para a sua localização.Por favor Contate-nos Para obter mais assistência.

Carregando...

Enviar para

United States
Estoque em: china

cor:

Selecione um cor
Quantidade:

Special discount has ended

Please note each user for only 1 item(s)

Arrival Notice

if the goods arrival in 90 days,we will inform you by email!

Email:

Arrival Notice

Notification Subscription Success!

if the goods arrival in 90 days,we will inform you by email!

Notification Subscription Failed!

Error appeared,Please try again later!

Arrival Notice
Adicionar aos favoritos

Compartilhar:

Características:
Digital display com cara preta e o LED azul.
usado para medir a temperatura do óleo do automóvel.
. faixa de medição é 40 ~ 150 graus Celsius.
luz vermelha de advertência.
alta precisão e fácil operação.

especificações:
cor: preto
LCD tamanho: 52 milímetros/2 in
unidade: grau Celsius só
faixa de medição: 40 ~ 150 graus Célsio
ponto aviso: 100 graus Célsio
poder: 12V DC, Max. 0.3 a
linha de montagem do Sensor: NPT 1/8"
tamanho do calibre da temperatura de óleo: 5.7 * 5,5 cm / 2.2 * 2.2 in (diâmetro * altura)
peso do calibre da temperatura de óleo: 57 g/2oz
tamanho do pacote: 17 * 12 * 7,8 cm / 6,7 * 4.7 * 3,1 no
peso do pacote: 216 g/7,6 oz

pacote incluindo:
1 *
medidor de Temp de óleo 1 *

Discussões

Publicar um novo tópico

Por favor, note que o TOMTOP Forum é uma comunidade para troca de ideias e ajuda a procurar, durante o qual os entusiastas da tecnologia participarão na discussão, enquanto isso, o serviço de atendimento ao cliente da TOMTOP (com o ícone do serviço ao cliente Tomtop) será oportuno, com a mesma função que o contato em http : //www.tomtop.com/contacts

abra este fórum em página completa
Avaliações de Clientes

Avaliação Média:

4.5

baseado em 119 Avaliações de Clientes

  • 5 Estrelas
    50%
  • 4 Estrelas
    41%
  • 3 Estrelas
    9%
  • 2 Estrelas
  • 1 Estrelas

Compartilhe seus pensamentos com outros clientes e obter TOMTOP Pontos, os primeiros 5 avaliações obter o dobro TOMTOP Pontos!

Escreva comentários de Cliente
  • By john l

    July 13, 2017

    Gauge worked on the first try, ran the green wire to tach output off the coil on a 350 TBI. It won't read any rpm until the engine is actually running, not sure if that's my truck or the gauge.. But it seems to react reasonably quick and read accurately. The gauge pod is very cheap though and mine was missing the back side of the nut, so I had to drill it out and make a new nut/bolt... But still a cheap way to add a tach to a truck. Update, now that i wired the LED backlight, it is WAY too bright for nightime use, I wish there was a way to dim the backlight some, I wired mine to a switch so I can turn it on and off. Also you can combine the two black negative leads (one for the tach and one for the LED) at the same spot, works fine and makes wiring a bit easier

    Is this helpful? (0) (0)

  • By arthur senior

    July 7, 2017

    I bought this because I wanted a engine tach for both of my tractors, however this tach is designed for vehicles and will accommodate a 4 cylinder, 6 cylinder, or 8 cylinder engine. Install was pretty simple, red wires to ignition positive, black wires to ground, green wire to the negative side of engine coil. Then I screwed the gauge down onto the dash. Installing on a vehicle is exactly the same. I love the pretty blue glow from the gauge light, and best of all, the gauge is very responsive! When idling, the needle on the gauge stays right at the RPM it should be and won't jump around like a race horse unless your engine is jumping around lol. While reving the engine, I get an instant response from the gauge, definitely a lot quicker then some digital tach's ive seen. The gauge isn't too big in size, about 2" or so, which means it can fit within a small space, unlike the big 5" gauges. Highly recommended.

    Is this helpful? (0) (0)

  • By r***m

    July 6, 2017

    The tach works good really good but the back light is way to bright even when hooked into the factory dimmer switch instalation was about 3 hours because instructions where limited and resorces online for my specific vehicle where limited when trying to find schematics for my factory dimmer switch and like many have stated the back light is wayyyyy to bright they would of been better off using a regular dash bulb for this thing think im just gonna cut the back light wires and leave it as a none back lite tach over all for the price of this thing its definitly worth it

    Is this helpful? (0) (0)

  • By andrew j. rudlang

    July 6, 2017

    Works pretty good, looks nice. Heads up to anyone with a three cylinder car like a geo metro or chevy sprint, there is a potentiometer on the circuit board which allows enough adjustment of the resistance to make this read properly for a three cylinder car. If you have access to a scope and square wave generator and other cool equipment you can dial it in precise although the POT is a bit touchy. If you just want it roughly close then put it in 6 cylinder mode and hook up to your car, get someone with a steady foot to rev the engine until the gauge reads 1500 (which should be 3000 RPM on your 3 cylinder) then switch it for 4 cylinder mode and adjust the POT until the gauge shows 3000 RPM. Full disclaimer that is just an idea for those without the fancy equipment my electrical engineering friend had, we went the cope+square wave generator route.

    Is this helpful? (0) (0)

  • By dave h

    July 6, 2017

    Nice little tach for the money. I felt that the instructions were lacking quite a bit, but I was able to figure it out. There are two long red and black wires - these provide power. The red should be hooked to a 'key hot' wire. There are two shorter red and black wires - these are for the backlight. The red wire here should be hooked to a wire that gets hot when the parking lights are turned on. Finally the long green wire needs to be hooked to the signal for the distributor. For my Chevy HEI ignition, this was a wire directly to the distributor cap. The response of the needle is nice and smooth, not choppy or jittery. The backlight is a very bright blue. The bezel is just ok, the holes in the back of it for the wires to pass through are on the wrong side for how I have it mounted (base down to the top of my dash). This seems wierd to me, the wires come out of the top of the tach itself when oriented upright. Didn't seem to cause any problems though.

    Is this helpful? (0) (0)

  • By tanya ferguson

    July 6, 2017

    Two out of three of these worked well. I put one in my 1955 jeep last year, and it is very nice to see exactly how much oil pressure. The old jeep has oil pressure issues and is in need of a rebuild on the motor so this gauge helps me watch things until I can get it taken apart. The gauge seems accurate as I compare to the old gauge. This year, ordered one for my 1946 cj2a jeep. It worked for about 1 minute. I just rebuilt the motor and I NEED to see the oil pressure to ensure all is well. I dis-assembled the gauge and found the Voltage regulator pop'd. I was hoping for a bad solder joint or something. Anyways, I ordered a 3rd and that one arrived in two days. I postponed my first time startup on the rebuilt engine until I had a gauge. Connected the 3rd one and It has been working every since. The one that blew was not cross wired...it worked then just went out. Not sure what to make of the one bad gauge out of the three I ordered.

    Is this helpful? (0) (0)

  • By nico c.

    July 6, 2017

    I installed this tach in my '80 suburban to find out my rear axle gear ratio lol. Works like a charm and what I suspected: 3.73s. The gauge housing that was included bolted to the dash faceplate perfectly.The needle shows RPMs smooth, not jumping around. Yes the blue light is bright at night, not so noticeable in the day light. Overall very good for the price. Only downside is the bulb cant be changed for a different color.

    Is this helpful? (0) (0)

  • By k***k

    September 16, 2017

    Great Seller, Great Product.

    Is this helpful? (0) (0)

  • By s***s

    August 25, 2017

    Fast delivery - good price and nice product

    Is this helpful? (0) (0)

  • By jack t.

    July 15, 2017

    This taco meter worked great on my volkswagen beetle. Set up was simple, installation a breeze. My main complaint is the backlight. If you enjoy a pleasant night drive free from being blinded by your own genious then I would recommend not hooking up the led back light. Maybe someone can answer my question, can you use a control dimmer knob on the led function of this tac? Any input would help. Over all perfect function of product, just a little bugaboo with the backlight that's all. ~Jack

    Is this helpful? (0) (0)

  • By angela mangum

    July 14, 2017

    Very easy to install. Only complaint is that it is very bright when driving at night. Needs a way to dim it.

    Is this helpful? (0) (0)

  • By bonnie b. bazar

    July 14, 2017

    works fine, so far. easy to install.

    Is this helpful? (0) (0)

  • By mike

    July 13, 2017

    Never heard of this brand before so was unsure about it at first but it works great as any other tach I have ever used. Plus you can not beat the price.

    Is this helpful? (0) (0)

  • By marc

    July 12, 2017

    Only complaint is that it is a little too bright at night.

    Is this helpful? (0) (0)

  • By stephen cardillo

    July 7, 2017

    Good for the price

    Is this helpful? (0) (0)

  • By david hickey

    July 5, 2017

    I agree with some of the reviews the instructions could have been s little clearer but the end result if you persevere is awesome a great product and an incredible value... Trust me I did my research and this product is the bomb.

    Is this helpful? (0) (0)

  • By a***2

    January 4, 2016

    Sehr schneller Versand.War am nächsten Tag da.Gerne wieder!

    Is this helpful? (0) (0)

  • By t***l

    September 7, 2015

    Very quick great seller

    Is this helpful? (0) (0)

  • By g***y

    January 14, 2015

    Item as described, thank you for a smooth transaction :)

    Is this helpful? (0) (0)

  • By r***o

    January 2, 2015

    Good seller

    Is this helpful? (0) (0)

Evento Quente Mais

Top vendas Mais

Por favor, ative o seu e-mail registrado, se não recebeu seu e-mail de ativação, por favor clique no botão abaixo

Recently Viewed