This is the R2008SB 2.4GHz S.Bus S-FHSS 8 Channel Receiver for use with the Futaba 8J 2.4GHz Computer Radio System. The R2008SB has an S.BUS system output
port and a conventional system channel outputs. It can also be used with conventional system servos, etc, in addition to S.BUS system compatible servos and gyros, etc.
4.8 - 7.4V high voltage operation
Frequency hopping Spread Spectrum design
S.Bus system output port and conventional system channel outputs optional
Dual Antenna Diversity, maximiz signal reception and promote safe modeling and can obtain RF signals on both antennas and fly problem free
Modulation: S-FHSS or FHSS
Voltage Input: 4.8V-7.4V battery or with BEC output ESC
Capable of 4 channels only in FHSS mode
Antenna length: 145mm
Compatible Batteries: NiCd, NiMH, LiPo, LiIon or LiFe
Item Dimensions: 4.3 * 2.5 * 1.4cm / 0.98 * 1.69 * 0.55in
Item Weight: 9.5g / 0.34oz
Packag size: 8 * 6 * 3.5cm / 3.2 * 2.4 * 1.4oz
Package weight: 49g / 1.7oz
Gift Plastic package
Futaba F-FHSS/FHSS system does not work with current Futaba FASST system. Futaba FASST system and S-FHSS/FHSS system are mot compatible each other.
Wrap the reciver with something soft, such as foam rubber, to avoid vibration. Moreover, the receiver must not get wet.
Keep away from conductive material to avoid the short circuit.
Binding to the transmitter:
Step 1: Bring the transmitter and the receiver close to each other within 20inchs(Half meter)
Step 2: Turn on the transmitter
Step 3: Turn on the reciver(connect the battery and ESC)
Step 4: Press and hold the link switch more than 2 seconds.
When the link is complete, the LED in the receiver changes to solid green.
There may be other conditions can cause the transmitter and the reciever cannot bind.
1. There are radio interference in your surrounding environment, try to bind them by make the transmitter antenna and receiver antanna touched.
2. There are many S-FASS/FHSS system turned on in your surrounding environment.In this case , even if the receiver's LED stays solid green, unfortunately the
receiver might have bind to one of the othertransmitters.This can be very dangerous. In order to avoid this problem, we strongly recommend you to recheck
whether your receiver is under control by push the pitch or aileron channel to check the servo response.
Antenna installation precaution:
Do not cut or bundle the receiver antanna wire
Do not bend the coaxial cable, it may cause damage.
Keep away the antenna away from the motor, ESC and other noise sources as you can.
Be sure that the the two antennas ar placed at 90 degrees to each other.
Please make sure that the exposed portion won't b slided back in the fuse by the wind or other force during the flight session.
1 * Futaba R2008SB Receiver
1 * English manual