Simple structure and light weight, comes assembled and tuned for Gopro Hero3 3+.
With 2pcs 2208 brushless motors and Martinez gimbal controller with IMU.
Including anti-vibration mount for DJI Phantom.
Pre-soldered remote pitch control (you can also add roll control as you wish).
Supports Manual Pitch Control Range: ±180 degrees, Roll Control Range: ±90 degrees.
Has space for Gopro 3 FPV video cable.
2S- 4S LiPo battery powered.
Motor: Model 2208 KV80 Brushless motor
Control Panel: BGC2.0 Brushless control panel
Software: BGC 2.2
Material: Carbon fiber
Strap: For GOPRO camera strap
Compatible Camera: For GOPRO 3 3+ series
Mounting plate pitch: 20mm/ 0.79in
Battery plug type: JST plug
Compatible model: For DJI phantom I, II, walkera x350 etc.
Item weight: 225g/ 7.9oz
Package size: 18 * 13.5 * 9cm/ 7.1 * 5.3 * 3.5in
Package weight: 371g/ 13.1oz
How to install :
1. Remove the damping balls, open the top cover of the mounting plate;
2. Install the top cover of the mounting plate to the bottom of the DJI phantom
3. Install the damping balls.
4. Install your GOPRO 3 3+camera, and fasten it with straps.
Please do not energize the PTZ until the battery is mounted in the GOPRO 2 3 3+ camera which is fixed on the PTZ. Otherwise, the center-of- gravity position of the PTZ will shift, which will makes it vibrate. Power supply of the PTZ is recommended as 12V.
We test and tune every single brushless gimble before shipping to ensure the ease of use.
Please make sure the positive and negative terminals of the item are correctly connected. Misconnection will lead damage to the control board, which is Not under warranty.
Not included the Gopro & DJI Phantom.
Before power the Gimbal, please make sure the Camera has been installed; Or the Gimbal Controller may get damaged！
1 * Brushless 2-axis Gimbal (Fully assembled and tuned)
1 * Anti-Jello Mount for Dji Phantom
1 * Installation accessories