Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Q & A
Yes that is its exact application. Weighs: 11g
By Action Bracelet on March 29, 2018
22.2v 6s lipo pack
By Megumi Asakura on May 9, 2018
I don't believe it does, you may have to make one
By Kevin M. on May 2, 2018
when I used them in 5volt, and they tended to be on the high side of 5 volts under load(around 5.2) they work great as a BEC for RC. ^ volt seems closer. they didn't come with a sheet, I used them as-is, never looked around for any docs. 7.2 and 11 volts seem to work fine.
By Stephen P. on April 22, 2018
Are you sure you are testing from +5 to ground and not to + 9? Seems unlikely that two would be bad. Your battery chemistry should not matter.
By George on April 18, 2018
The 5v side has a standard servo connector, the input side has nothing, just bare wire so you can solder to your power distribution board.
By Joby on April 16, 2018
Depends on the amps and voltage required for the lights. I would also not purchase this one, I have purchased two and both were solder incorrectly. Look into the Turnigy, they are well built with less RF.
By Kent G. on April 4, 2018
as long as you do not exceed the rated output of the ubec you should be ok to split the voltage however you wish.. once you overload it , it will fail..
By Michael Adams on February 14, 2018
Voltage will be 100% 5v or 6v optional, current 3A
By Azusa Ikemura on July 19, 2017
No, I have used this same one for years with my osd, lights, flight controller, etc. Works great!
By Clint Harris on June 21, 2017
に基づいて 180 お客様の評価
January 7, 2018
December 16, 2017
November 14, 2017
April 10, 2017
January 13, 2016
January 6, 2016
January 5, 2016
December 1, 2015
September 29, 2015
September 28, 2015
September 25, 2015
September 14, 2015
September 8, 2015
September 8, 2015
August 27, 2015
July 29, 2015
March 30, 2015
February 13, 2015
February 9, 2015
December 19, 2014