Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Q & A
it depends on your esc .
By Jack on May 20, 2018
Model No.:A 2212 /5T, Rpm/V: 2700KV, According to the specs, it turns 2700 RPM per volt. With a high pitch prop, it will turn slower and use more amps. This is a very stong motor, I use 9, 10, & 11 (4.7 pitch) inch props on my 5T. My foam aireplanes weight from 1 to 2 lbs. Hope this helps.
By Frank on May 17, 2018
IT would depend on the size of prop you use. The description says you can use a 30 amp esc. Do some research on that motor to see what size of prop has been used. I don't remember much about it. It has been a long while since I used it. A clamp on meter would tell you how many amps the motor is drawing. This is a good… see more IT would depend on the size of prop you use. The description says you can use a 30 amp esc. Do some research on that motor to see what size of prop has been used. I don't remember much about it. It has been a long while since I used it. A clamp on meter would tell you how many amps the motor is drawing. This is a good investment ( about $50) if you are going to stay in the hobby. Join RCGroups and ask the question on that forum. They are usually very helpful. Don see less
By Don Brasier on April 24, 2018
I have several of these motors in small scratch built foamie parkjets. I run both APC and EMP brand 6x4 props. They are perfectly matched for this motor.
By Bill Powell on April 20, 2018
By Big D on April 9, 2018
Yes you will need to solder on bullet connectors
By jason miller on April 6, 2018
I believe 20 amp will run up to 2000 kv
By Jack on March 15, 2018
I use 2200 mah 3s batteries and get plenty of power.
By Bill Powell on March 10, 2018
Sounds like a prop issue
By jason miller on January 23, 2018
Lipo 1000mah 20c with 20a esc
By mason on June 18, 2017
に基づいて 14 お客様の評価
April 5, 2017
December 23, 2015
December 22, 2015
October 16, 2015
October 2, 2015
September 21, 2015
September 11, 2015
September 10, 2015
September 9, 2015
September 4, 2015
September 2, 2015
August 28, 2015
October 20, 2015
May 2, 2015