2.4 G 4 ch ラジオ モデル RC トランスミッタ & レシーバー

2.4 G 4 ch ラジオ モデル RC トランスミッタ & レシーバー







  • 中国倉庫
通常は出荷されます 営業日 時間
ご希望は答えられません もう一度お願いします.
すみません、入力したアドレスまで届けませんお願いします こっちに連絡してください 助けを求める.



United States
在庫: china

Special discount has ended

Please note each user for only 1 item(s)

予約受付 カートに入れる 在庫がありません

Arrival Notice

if the goods arrival in 90 days,we will inform you by email!


Arrival Notice

Notification Subscription Success!

if the goods arrival in 90 days,we will inform you by email!

Notification Subscription Failed!

Error appeared,Please try again later!

Arrival Notice



Q & A

  • Q Bonjour Quel servo utiliser? Merci.

    By Bertrand July 28, 2017

    A servo with futaba or JR connector

    Reply By Customer Service Center July 28, 2017



TOMTOPフォーラムはアイデア交換の場であり、ITエンジニアがディスカッションに参加するのを助けるコミュニティです。一方、TomTopカスタマーサービス(Tomtopカスタマーサービスアイコン付き)は、httpの連絡先と同じ機能でタイムリーに対応します ://




に基づいて 110 お客様の評価

  • 5 星
  • 4 星
  • 3 星
  • 2 星
  • 1 星


  • By Scarlett McLain

    October 12, 2017

    Worked for all of two days before quitting none of the sticks respond anymore even though the receiver shows its bound. I've tried reloading settings, rebinding the receiver and nothing. The only input that's registered is down on the right stick, but the receiver doesn't even pick that up. I have no idea what happened. It was working fine and suddenly stopped working all together. Edit: After searching some fours and researchING my problem further I realized my transmitter only needed recalibration. I had to buy the digital radio software, but it is only $2 and is well worth the investment. If you buy this radio, then you really really should buy digital radio as well. You can get a free demo, but you'll need to buy it to do the calibration. Minus one story for one of the toggle switches breaking after a couple days of use, but I'm tech savvy and was able to easily replace and fix the switch.

    Is this helpful? (0) (0)


    May 22, 2017

    Good system for the price. if you need instructions to set these systems up, you should be buying at your local hobby shop and pay the price. i am currently using ten of these radios and have not purchased anything else for the past three years. I fly fifteen hundred flights a year plus and several of these systems have well over one thousand flights on them. only problem i have ever had is when ordering replacement receivers usually for crash damage. and i have yet to receive one that would. work. forget about returning anything made in China even if it is defective. you bought it you got it and it is not worth the time or money to return anything. ACCAFLITE RC.

    Is this helpful? (0) (0)

  • By D. Darby

    May 13, 2017

    -.75 for not having a return-to-zero spring on the left side and another .25 for including non-standard dis-assembly screw heads. I found the following instructions on the net: On the 6 channel receiver the top connector is the battery connector and it is also where you put the bind plug in when binding it. If you only have a 2 pin battery plug make sure you plug it in so that the black wire is on the right and the red wire is in the middle, the pin on the left will be empty. If you have a 3 pin, 2 wire connector the same applies but you won’t have an empty pin. This is all clearly marked on the receiver. ** If you plug it in wrong you will blow up your receiver ** Now let’s get started; 1) Plug the battery plug into channel 1 (remember red wire in the middle, black on the right). 2) Plug the bind loop into the top connector (marked BAT). 3) There should now be a little red flashing light at the top of the receiver. 4) Put batteries into your transmitter and look at the front of it. 5) On the bottom left hand corner there is a small black circle (BIND RANGE TEST is on the left). 6) Press and hold this circle in and whilst holding it down turn the transmitter on. 7) The flashing red light will now be solid red. 8) Remove the battery plug from the receiver. 9) Remover the bind plug from the receiver. 10)Turn the transmitter off (this stores the settings). The transmitter is now bound to the receiver so when you next plug the battery plug in and turn the transmitter on the red light will come on solid showing it is ready to go.

    Is this helpful? (0) (0)

  • By b***8

    January 14, 2016

    Pleasent transaction would buy from seller again

    Is this helpful? (0) (0)

  • By s***2

    January 8, 2016

    Good product and shipping. Thanks!

    Is this helpful? (0) (0)

  • By i***1

    January 5, 2016

    Shipped fast and delivered sooner that expected!! Very happy

    Is this helpful? (0) (0)

  • By t***x

    September 27, 2015

    alles bestens

    Is this helpful? (0) (0)

  • By p***7

    September 24, 2015

    prompt dispatch excellent packing

    Is this helpful? (0) (0)

  • By c***o

    September 6, 2015

    fantastic e-bayer. Great communication and great item. Thank you.

    Is this helpful? (0) (0)

  • By f***t

    September 5, 2015

    schneller Versand, vielen Dank !

    Is this helpful? (0) (0)

  • By s***1

    April 9, 2015

    good item.correct seller.

    Is this helpful? (0) (0)

  • By s***5

    March 28, 2015

    Works great!

    Is this helpful? (0) (0)

  • By t***6

    February 19, 2015

    well packed and quickly shipped

    Is this helpful? (0) (0)

  • By b***n

    February 10, 2015


    Is this helpful? (0) (0)

  • By f***b

    January 19, 2015

    Excellent, thank you. A ++++++++++++++++++++++++++++

    Is this helpful? (0) (0)

  • By t***2

    January 10, 2015

    Fast shipping

    Is this helpful? (0) (0)

  • By j***d

    January 2, 2015

    great thank you

    Is this helpful? (0) (0)

  • By t***6

    December 18, 2014

    Item as Described,Quick Postage, Great Seller

    Is this helpful? (0) (0)

  • By l***c

    December 10, 2014

    Transmitter as Described and Fast Shipping

    Is this helpful? (0) (0)

  • By p***u

    December 2, 2014

    good stuff, nice service

    Is this helpful? (0) (0)

人気商品 もっと見る

人気商品 もっと見る


Recently Viewed