Prix uniquement sur l'application:
Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
One End Gets Wrapped Around The Spark Plug Boot And The Other End Snaps IN to The Plastic meter.
By Jim Reilley on July 11, 2017
just wrap meter wire end 5 or 6 times around the lower end of spark plug wire. That's it! Works great.
By Pete on March 12, 2018
Yes it should.
By Rebecca Woods on February 26, 2018
I would say it's over 2 feet long. Can't get to mine for an exact measurement due to a foot of snow blocking my tractor shed!
By Pete on February 17, 2018
I don't believe so. Just continuous run time
By marple200 on February 1, 2018
No. It will just record hours
By Jonathan Reese on January 18, 2018
Yes It works perfect Very simple instructions … see more Yes It works perfect Very simple instructions I have them on all of my small engine machines Log splitter, mowers, atvs Wire pushes into slot along back side of Meter, 1/2" length of wraps of wire around spark plug wire and your done I usually add a few wraps of electrical tape to keep the wire in place around spark plug wire Hope this helps see less
By Stephen Welch on December 19, 2017
Battery is not replaceable it does not say if it is waterproof i. Used 2 screws that came with it to mount to a bracket
By Adigio on November 21, 2017
In 2-3 years when the battery dies and the unit "may" go back to zero (presuming that this does not have circuit board memory)., then the unit is cheap enough to just replace. Even if you could replace the battery, more than likely it would still zero-out when you replaced it. Most people use hours meter just to mark s… see more In 2-3 years when the battery dies and the unit "may" go back to zero (presuming that this does not have circuit board memory)., then the unit is cheap enough to just replace. Even if you could replace the battery, more than likely it would still zero-out when you replaced it. Most people use hours meter just to mark service intervals and this meter goes to 9999.9 hours...that's a lot of intervals. see less
By J. FORD on November 18, 2017
Yes it will it has nothing to do with that fuel injection when the engine is running it senses electricity flowing through the spark plug coil or from the coil to the spark plug all you have to do is wrap it around one of the spark plug wires that's all you have to do wraparound that thing when you cut the motor off it… see more Yes it will it has nothing to do with that fuel injection when the engine is running it senses electricity flowing through the spark plug coil or from the coil to the spark plug all you have to do is wrap it around one of the spark plug wires that's all you have to do wraparound that thing when you cut the motor off it stops registering when you turn the motor back on it starts counting your time again see less
By Just me on October 30, 2017
Notez que TOMTOP Forum est une communauté pour l'échange d'idées et la recherche d'aide, au cours de laquelle les enthousiastes technologiques participeront à la discussion. Pendant ce temps, le service à la clientèle TOMTOP (avec l'icône Tomtop Customer Service) répondra en temps opportun, avec la même fonction que le contact sur http : //www.tomtop.com/contactsouvrez ce forum en pleine page
basé sur 279 Avis des clients
Partagez votre opinion avec les autres clients et obtenir des points Tomtop, les 5 premiers examens obtiennent le double de points Tomtop!Écrire un avis de client
By Ryan Lester
September 21, 2017
Bought this for a Predator 212. It screwed right into the airbox without a drill. and I coiled it around the spark plug 7 times so it would register. My wire was roughly 4 feet long. It works as it should. There is a battery on these things and only time will tell how long it lasts. The thing is sealed so either you will have to break it open to swap the battery or buy a new one. But if it were to not be sealed then it wouldnt be waterproof so nobody can really find one thats waterproof and not sealed. But overall I do recommend this product
By Online Shopper
August 20, 2017
Purchased for my Honda eu2000i generator (that does not come with an hour meter). Five wraps around the spark plug wire starting at the boot and easy to fish the wire thru to the meter mounted (via provided screws) to the top of the case near the handle. Cut away the excess wire that was not needed and it starting working when the generator was started. Measures tenths (one 10th = 6 minutes) and whole hours. This is needed to track when to change the oil. Only likely issue will be the non-replaceable battery.......when it runs out, time to buy another one. Unsure how long battery will last.
By Benjamin B.
August 16, 2017
It works. Instructions didn't mention where to put the other end of the wire, but it's pretty obvious I guess (in the slot of the meter's case). Meter display remains on at all times, the little hour-glass blinks when the motor is operating (if you wired it correctly and it's not broken). It remains to be seen how long it'll last being on all the time like it is, but as long as I write down the time every couple weeks or so I should be fine even if it dies. For a few bucks, it's not bad. For installing the wire, I zip-tied one end parallel to the plug wire, made a 90-degree bend and wrapped it tight exactly 5 times (ending on the same side of the plug wire that I started on), made another 90-degree bend to get parallel again, then zip-tie tight so the coil doesn't get loose. Would have also put heat-shrink on at this point, but didn't have any big enough to fit over the boot that could also shrink to fit the wire. After installing the coil, I simply routed the wire around the motor shroud, installed the meter on the wire where I wanted it mounted, then stuck it in place with some heavy-duty scotch 3m fasteners.
August 4, 2017
Bought this to track the hours on my Crraftsman R1000 lawn tractor. Works great. I used double sided 3M outdoor tape to attach it on a recessed area near the oil cap. Just a few minor things to be aware of; I needed to remove many parts from around the engine to get at the spark plug wire. Not a fault of the meter. Just the nature of the design on this particular mower. When I finally got to the plug wire, I wrapped the sensor wire 5 times around the spark plug wire approximately 3/4" from the boot. I tie wrapped everything securely and routed the sensor wire up to an opening near where I planned on mounting the meter. I ended up with about 6" of extra wire length, so I snipped that off to keep everything neat. The instructions are not clear on how the wire inserts into the meter. I ran the wire the full length of the meter and forced it all the way into the base pf the slot. Also be aware that although the instructions refer to double sided tape, there is none provided. They do give you two small self tapping screws which you could use if you wanted to drill a couple of holes. The meter is very light in weight, therefore I used my own double sided tape to securely attach the meter, without using the screws. One other minor thing, again not a fault of the meter, is the red color. From the picture, I thought it would match the red panels on my mower. This isn't the case. If I knew there would be such a noticeable difference in color, I would have ordered black. But that's just me being OCD! All in all, the meter does the job, and I feel it is well worth the money.
By Marjorie W. Dunaway
October 3, 2016
by Marjorie's hubby: I bought 2 of these to put on my snow blower and generator to track usage. Finally got round to installing one on the snow blower. The concept is simple but my snow blower engine is encased in several shrouds and it was tough to access the spark plug cable. Once I got there and managed to get the 5 wraps on, things were simple. BUT for a few moments I was uncertain how to install the wire on the unit - it is simple, just tuck the wire in the slot along the base of the unit. A little more instructions on the card would help. I held back a star as I've only had it installed for 2 days - but I like it a lot - hope it is durable. I was surprised that it recorded I'd run the machine for 2 hrs already. Now I hope to be more prompt and diligent in oil changes. I expect it will pay off in better maintenance and longer life of the engine. Now to install on the generator which also has a deeply buried spark plug..
By Mark Nakamura
August 22, 2016
Hooked this up to my new Yamaha EF1000 generator and it works great. Easy to install (just wrap one end of the included wire around the spark plug wire close to the plug and stick the other end into the slot on the meter. It comes with two screws to attach it but I used double sided tape and placed it on top of the generator spark plug access hatch. Good price (half that of the Yamaha branded version) and seems to be working just fine. It has an internal non-replaceable battery and I am not sure how long it will last, but for the price if I get 2 or 3 years use out of it I will be happy.
August 18, 2016
It works. Wish you could change the battery when it goes dead. I installed this on my generator. It reads in tenths. So .5 is 30 minutes, 1.0 is 60 minutes, 1.5 is 90 minutes and so on. Hook up was easy. Just wrapped the wire around the end of the spark plug wire, as close to the spark plug as I could, 5 times. Instructions are vague. The wire needs to be inserted the full length of the slit in the back of the meter. Does not explain this in the bad directions. If I could change the battery, this would be 5 stars. Overall I'd buy this again and recommend it to others.
December 1, 2017
By Marco D
September 2, 2017
I gave this to a friend as a gift for his pit bike. It was easy to install and works great. The order was placed for a blue unit, but a black one was received. We decided to install it anyways, but it would have been nice to receive the correct colored item (which was priced higher than the standard black one by a couple dollars) since I wanted it to match his bike color.
By Ritzville Jerry
July 31, 2017
I like it. It doesn't even require a battery. Rap the sensing wire five times around the spark plug wire and you are done. That's it. It can be tie-rapped onto your motor or can be screwed onto the case. I am using it on my new generator. I checked it for 45 minutes and it was right on.
By Joe Wilhem
August 13, 2016
January 16, 2016
September 6, 2015
April 16, 2015
March 17, 2015
March 11, 2015
February 23, 2015
February 14, 2015
February 3, 2015
January 24, 2015
Meilleures ventes Plus
Votre question a été soumise avec succès
Veuillez activer votre e-mail d'inscription. Si non reçu cliquez sur le bouton ci-dessous
NOTRE SITE RUNS OF COOKIES