Prix uniquement sur l'application:
Special discount has ended
Please note each user for only 1 item(s)
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
No just shows run time.
By JW on April 12, 2018
Yes, I trim all the excess wire off of mine. Have this on 2 machines with 0 issues
By Austin on April 7, 2018
No , you throw it away when the battery goes dead in 3-4 years .
By BOB on April 6, 2018
I never had that problem before I own two of these are use them on my boat the only thing I can think of is if you have the meter or I should say the wire too close to an electrical source it could be picking it up thinking that it's actually running and it will count how long that is running for but I have no explanat… see more I never had that problem before I own two of these are use them on my boat the only thing I can think of is if you have the meter or I should say the wire too close to an electrical source it could be picking it up thinking that it's actually running and it will count how long that is running for but I have no explanation on the times I never had that happen I have two of them they worked flawlessly see less
By Just me on March 12, 2018
Yes. Just tuck it in the length of the body slot and your done.
By Mark Patterson on March 8, 2018
It displays the run time, it shows hours and then each tenth of an hour.
By Erina Wada on February 19, 2018
no. It has to be hooked to a spark plug. but for gasoline engine the thing works great.
By Rickey on February 7, 2018
It works by inductively sensing current in the spark plug wire so you should have no problem.
By OhReally on January 19, 2018
As long as it has a spark plug wire to pick up a signal from.
By Seth P on February 7, 2018
My old tiny tach could be zeroed, and then reset back to X hrs that way, think it had to be single wire not cord with 2 wires.
By Kevin on January 25, 2018
Notez que TOMTOP Forum est une communauté pour l'échange d'idées et la recherche d'aide, au cours de laquelle les enthousiastes technologiques participeront à la discussion. Pendant ce temps, le service à la clientèle TOMTOP (avec l'icône Tomtop Customer Service) répondra en temps opportun, avec la même fonction que le contact sur http : //www.tomtop.com/contactsouvrez ce forum en pleine page
basé sur 272 Avis des clients
Partagez votre opinion avec les autres clients et obtenir des points Tomtop, les 5 premiers examens obtiennent le double de points Tomtop!Écrire un avis de client
By Ryan Lester
September 21, 2017
Bought this for a Predator 212. It screwed right into the airbox without a drill. and I coiled it around the spark plug 7 times so it would register. My wire was roughly 4 feet long. It works as it should. There is a battery on these things and only time will tell how long it lasts. The thing is sealed so either you will have to break it open to swap the battery or buy a new one. But if it were to not be sealed then it wouldnt be waterproof so nobody can really find one thats waterproof and not sealed. But overall I do recommend this product
By Online Shopper
August 20, 2017
Purchased for my Honda eu2000i generator (that does not come with an hour meter). Five wraps around the spark plug wire starting at the boot and easy to fish the wire thru to the meter mounted (via provided screws) to the top of the case near the handle. Cut away the excess wire that was not needed and it starting working when the generator was started. Measures tenths (one 10th = 6 minutes) and whole hours. This is needed to track when to change the oil. Only likely issue will be the non-replaceable battery.......when it runs out, time to buy another one. Unsure how long battery will last.
By Benjamin B.
August 16, 2017
It works. Instructions didn't mention where to put the other end of the wire, but it's pretty obvious I guess (in the slot of the meter's case). Meter display remains on at all times, the little hour-glass blinks when the motor is operating (if you wired it correctly and it's not broken). It remains to be seen how long it'll last being on all the time like it is, but as long as I write down the time every couple weeks or so I should be fine even if it dies. For a few bucks, it's not bad. For installing the wire, I zip-tied one end parallel to the plug wire, made a 90-degree bend and wrapped it tight exactly 5 times (ending on the same side of the plug wire that I started on), made another 90-degree bend to get parallel again, then zip-tie tight so the coil doesn't get loose. Would have also put heat-shrink on at this point, but didn't have any big enough to fit over the boot that could also shrink to fit the wire. After installing the coil, I simply routed the wire around the motor shroud, installed the meter on the wire where I wanted it mounted, then stuck it in place with some heavy-duty scotch 3m fasteners.
August 4, 2017
Bought this to track the hours on my Crraftsman R1000 lawn tractor. Works great. I used double sided 3M outdoor tape to attach it on a recessed area near the oil cap. Just a few minor things to be aware of; I needed to remove many parts from around the engine to get at the spark plug wire. Not a fault of the meter. Just the nature of the design on this particular mower. When I finally got to the plug wire, I wrapped the sensor wire 5 times around the spark plug wire approximately 3/4" from the boot. I tie wrapped everything securely and routed the sensor wire up to an opening near where I planned on mounting the meter. I ended up with about 6" of extra wire length, so I snipped that off to keep everything neat. The instructions are not clear on how the wire inserts into the meter. I ran the wire the full length of the meter and forced it all the way into the base pf the slot. Also be aware that although the instructions refer to double sided tape, there is none provided. They do give you two small self tapping screws which you could use if you wanted to drill a couple of holes. The meter is very light in weight, therefore I used my own double sided tape to securely attach the meter, without using the screws. One other minor thing, again not a fault of the meter, is the red color. From the picture, I thought it would match the red panels on my mower. This isn't the case. If I knew there would be such a noticeable difference in color, I would have ordered black. But that's just me being OCD! All in all, the meter does the job, and I feel it is well worth the money.
By Marjorie W. Dunaway
October 3, 2016
by Marjorie's hubby: I bought 2 of these to put on my snow blower and generator to track usage. Finally got round to installing one on the snow blower. The concept is simple but my snow blower engine is encased in several shrouds and it was tough to access the spark plug cable. Once I got there and managed to get the 5 wraps on, things were simple. BUT for a few moments I was uncertain how to install the wire on the unit - it is simple, just tuck the wire in the slot along the base of the unit. A little more instructions on the card would help. I held back a star as I've only had it installed for 2 days - but I like it a lot - hope it is durable. I was surprised that it recorded I'd run the machine for 2 hrs already. Now I hope to be more prompt and diligent in oil changes. I expect it will pay off in better maintenance and longer life of the engine. Now to install on the generator which also has a deeply buried spark plug..
By Mark Nakamura
August 22, 2016
Hooked this up to my new Yamaha EF1000 generator and it works great. Easy to install (just wrap one end of the included wire around the spark plug wire close to the plug and stick the other end into the slot on the meter. It comes with two screws to attach it but I used double sided tape and placed it on top of the generator spark plug access hatch. Good price (half that of the Yamaha branded version) and seems to be working just fine. It has an internal non-replaceable battery and I am not sure how long it will last, but for the price if I get 2 or 3 years use out of it I will be happy.
August 18, 2016
It works. Wish you could change the battery when it goes dead. I installed this on my generator. It reads in tenths. So .5 is 30 minutes, 1.0 is 60 minutes, 1.5 is 90 minutes and so on. Hook up was easy. Just wrapped the wire around the end of the spark plug wire, as close to the spark plug as I could, 5 times. Instructions are vague. The wire needs to be inserted the full length of the slit in the back of the meter. Does not explain this in the bad directions. If I could change the battery, this would be 5 stars. Overall I'd buy this again and recommend it to others.
June 12, 2018
October 10, 2017
By Karl T.
September 7, 2017
I bought this hour meter for my new Honda 2000i generator. It's single sense wire is wrapped around the spark plug wire several times and I fastened the meter to the generator with the included double stick tape. A disadvantage of this meter is the battery is not replaceable. I will continue to look for another meter that has a replaceable battery.
By Ritzville Jerry
July 31, 2017
I like it. It doesn't even require a battery. Rap the sensing wire five times around the spark plug wire and you are done. That's it. It can be tie-rapped onto your motor or can be screwed onto the case. I am using it on my new generator. I checked it for 45 minutes and it was right on.
December 21, 2015
September 6, 2015
April 17, 2015
April 2, 2015
March 12, 2015
March 11, 2015
March 5, 2015
March 3, 2015
January 4, 2015
Agenda Evénements Plus
Meilleures ventes Plus
Votre question a été soumise avec succès
Veuillez activer votre e-mail d'inscription. Si non reçu cliquez sur le bouton ci-dessous
NOTRE SITE RUNS OF COOKIES