Mouse over to zoom in
17.07
GoolRC 3650 4Poles 5200KV Brushless Motor for 1/10 RC Car Boat
Price:
US$
17.07
Loading...
Ship to
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Questions & Answers
Yeah. As long as the sakura has standard size motor mount. Fits in my sakura xi sport
By randy on December 19, 2017
Could only find max voltage of 9.6.
By Brent Yatman on May 16, 2018
It can work but I would run a 11 tooth pinion or less and stock wheels . tried on my traxxas 4x4 with larger wheels and 13 tooth and it hesitated a lot off start . its the added weight I have on traxxas . I figure if its over 8 lbs give a little it might do the same .go with lower kV motor .
By steve on May 5, 2018
I bought a 120a but a 90a should work.
By Bashers United on YouTube on May 6, 2018
These banana plugs are 4mm sized , they will your esc. I would buy some spare 3mm and 4mm bullet connectors / banana plugs to have around in case sizes are not the same for future projects. This one is definitely 4mm, therefore it does fit the red at esc.
By Us Bank on May 6, 2018
This will fit in the E-Revo but this is more of a bash motor these dont tend to last long for a long-term motor I would get the Sidewinder combo
By Eric on April 27, 2018
It will fit but wouldnt use it . Truck to heavy . Better for two wheel drive traxass or cars .
By steve on April 1, 2018
The package says yes but haven't tried it.
By Jonathan H. on April 2, 2018
Worked fine with a low end brand 60a esc, so it should definitely work with a Velinion.
By Vexxy on March 25, 2018
Discussions
Please note that TOMTOP Forums are a community for all communicating and getting help each other. There will be some enthusiastic friends participate in your discussions. Of course TOMTOP customer service (with tomtop customer service icon) response is guaranteed ,which is the same way you contact us at http://www.tomtop.com/contacts
open this forum in full pageAverage Rating:
4.4based on 95 Customer Reviews
Share your thoughts with other customers and get Tomtop Points, the first 5 reviews get DOUBLE Tomtop Points!
Write a Customer ReviewBy Nicolas
March 29, 2020
By Israel A.
March 28, 2020
I have been using this motor for so long, it is amazing to increase the volcanic eruption speed from 17mph to 40-45. I'm not sure if it will run faster because the car loses control and I can remember that the fastest speed is 40 mph and the throttle is 3/4. I made a rookie mistake when choosing this engine for a 4x4 truck and I recommend against making the same mistake as me. Again, the product stands out in terms of speed, but it's a pain for a slow 4x4 cruise, because ESC believes the engine is stuck, and even the lowest grass has caused it trouble. I'll try to lower the cord and see if it works. If you are looking for an affordable fast motor, this is one of them.
By Dorothy
March 27, 2020
By John
March 27, 2020
By Jennifer
March 25, 2020
By Ian B.
March 24, 2020
By Daniel L.
March 24, 2020
Very good motor, we recommend you see if you want to switch to brushless or replace motor without spending a lot of money. After a hot summer shock, very good motor cables and high-quality bullet connectors don't get too hot, and high-quality machined cans and caps are missing at both ends. There is no clearance on the shaft, so you don't have to worry about damaging the bearings, and you can rebuild them by removing the screws on the back of the motor if necessary.
By Kathy
March 22, 2020
By Bonnie
March 22, 2020
By Donna
March 20, 2020
The motor rips up. Updated from the flash configuration of our ECX circuit. After 2 seconds, I had to squeeze the shoe's clutch and shift to a 14-tooth gear! (We also installed some bigger 120mm tires.) I have a custom wheel guard that will roll to a throttle under 20mph and hit directly. In all 3, the 2wd off-road vehicle is out of control in most cases. Any slippage caused by super smooth and easy entry will turn the truck backwards, so fast that you won't even be able to say "oh shh" before passing. I love hahaha.
By ***
December 9, 2018
By jim shull
January 18, 2018
By p***y
January 16, 2018
By 4***6
January 10, 2018
By steve
December 20, 2017
By bwracing24
October 28, 2017
By Ralo
October 21, 2017
By Dennis A.
October 16, 2017
By m***7
October 15, 2017
By g***1
October 15, 2017
