The SP Racing F3 builds on tried and tested software, processor and sensor technology to make your aircraft fly like it's on rails. The SP Racing F3 runs cleanflight which can be configured to suit your needs using a cross-platform GUI (FOR Windows/for OSX/for Linux). It supports a variety of aircraft, three, four, six-axis, eight-axis, fixed-wing aircraft and more. SP Racing F3 flight controller to provide a high-performance flight hand experience and design, has proven sensor algorithm, while also providing unmatched I/O capability, the new generation CPU design concentrated onto a compact PCB. SP Racing F3 to provide the functionality you all need, whether you are doing FPV competition, aerobatics, aerial photography is perfect.
Features:
Micro USB socket
Large-capacity flash memory
MPU6050 accelerometers and gyroscopes
Next-generation hardware for your multi-rotor
Flight Logging. On-board high-capacity black box flight log recorder - optimize your tuning and see the results of your setup without guesswork
Developer Friendly. Developer friendly debugging port (SWD) and boot mode selection, unbrickable bootloader
Broad RC receiver Support. Support SBUS, SumH, SUMD, spektrum1024 / 2048, XBus, PPM, PWM receiver. No external inverter
(built-in)
Next-Generation CPU. The SPRacingF3 has an ARM Cortex-M4 72Mhz CPU with Math co-processor (FPU) for efficient flight calculations that gets more done in less time. Loop times up to ~2x as fast as previous-generation STM32F1 based boards
No-Compromise I/O. Use all the features all the time; e.g. Connect your OSD + SmartPort + SBus + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors - all at the same time!
I2C Port. I2C port always powered, perfect for external sensors or always-on OLED Screen
Sonar. Sonar support for precision low-altitude hold
Buzzer port for audible warnings and notifications
Battery Monitoring. Battery monitoring ports for voltage and current
Integration with OSD and power distribution boards stacked perfect design
16 PWM I/O lines ESC, servo and traditional reception service. 8 using standard pins. 8 distributed over the side-mounted connector
Fully supports OneShot ESC, and to provide full support for the PID parameter tuning
Specialized programmable LED strip lights provide a variety of support to the aircraft heading, competitions and night flying
A symmetrical design of ultra-neat wiring
Electric wire pin, JST-SH socket or connect the pads. Optional straight needle or looper
Specification:
Standard version: supports standard contest and flying
CPU: STM32F303, 72MHz INC FPU
Panel: 36 * 36mm plate, 30.5mm mounting holes
Cable length: 110mm
Main Color: black
Net weight: 6g
4 * 4pin JST-SH socket
(I2C, SWD, 2 * UART)
2 * 8pin JST-SH socket
(PPM, PWM, serial port to receive, GPIO, ADC, 3V, 5V, GND)
8 * 3pin though-holes for pin headers for ESC/Servo connections
2 * 4pin though-holes for pin headers for 2x serial ports
1 * 2pin though-holes for pin headers for battery voltage
1 * 2pin though-holes for pin headers for buzzer
Package Information:
Package size: 10 * 8 * 2cm / 4 * 3.2 * 0.8in
Package weight: 22g / 0.75oz
Adhesive tape package
Package List:
1 * SP Pro Racing F3 Standard Version Flight Controller Board
2 * Cables (no cable joint)
2 * Cables (each has 6 cable joints )
9 * Electric rods (different sizes)