Price:
US$
16.21
Loading...
Ship to
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Questions & Answers
A hi sir, i wouldn't say all but most of them.
Discussions
Please note that TOMTOP Forums are a community for all communicating and getting help each other. There will be some enthusiastic friends participate in your discussions. Of course TOMTOP customer service (with tomtop customer service icon) response is guaranteed ,which is the same way you contact us at http://www.tomtop.com/contacts
open this forum in full pageAverage Rating:
4.4based on 38 Customer Reviews
Share your thoughts with other customers and get Tomtop Points, the first 5 reviews get DOUBLE Tomtop Points!
Write a Customer ReviewBy Patricia
February 20, 2020
This entry has some undocumented receiver limitations. It works well in a hobby receiver, but when it flies in the air, movies often appear on the surface, so I don't trust flying. In Rx, the control is sometimes not set to neutral after initialization. This usually shows, and I disconnected and initialized again without problems. I still use it on a wing with a gopro camera.
By Cecil
February 19, 2020
By Alan
February 18, 2020
By Rebecca
February 17, 2020
By Jim S.
February 13, 2020
By Samm
December 6, 2017
This thing is so great. For the Price I now own 2 and they just improve the smoothness and stability of your aircraft so much. Just put it in between your receiver and your servos. Comes with convenient short cables. Just be sure it's set up so as to dampen outside forces not worsen them in a positive feedback loop. The control surfaces should point in the direction they are moving. right wing up? Right aileron up. If you move the tail up, the elevator should move up... etc.
By d***s
October 20, 2017
By allen
October 9, 2017
Great performance. Low rate helps us to stay straight in a windy day. High rate helps our planes stay in an aerobatic move in the air. CH2 comes opposite than our plane's movement. I had to program it to reverse it. Programming is easy for a tech guy. Each time you trim the controller, you have to re-calc the center, which is done by flipping the hi/off/low control quickly 2 to 3 times in a second.
By k***o
September 18, 2017
By Benjamin M.
September 11, 2017
By chrispybacon0069
September 8, 2017
By B. Allen
August 30, 2017
This thing is amazing and amazingly easy to use. I have am this in a HobbyKing Mini Skywalker and the P1 is the perfect size for it. I don't use rudder on the skywalker and use the tiny Frsky D4r-ii receiver and the P1 might as well have been designed to specifically work with it. Both are extremely light weight as easy to use. Unlike many other gyros the P1 can reset center position mid flight so your trims don't mess up AVCS mode and the airplane just behaves exactly how you want in any condition. I wish someone would take this unit and add a basic gps rth function. It would make the perfect system for general fpv in smaller planes.
By Anh Phan
August 8, 2017
This little boy works surprisingly well for the price. I received it yesterday, had a bit trouble installing the unit but after 20 minutes everything was set. I set the sensitivity at about almost 3/4. Tested and flew it today at ~12mph wind and man my glider handled so much better under the wind. I will update in the future regarding the reliability of the product. But so far I really like it for the price.
By Ken in Orlando
July 6, 2017
Fast shippinng, exactly as advertised. Unit is very small and light. Included all cables to hookup to my SLT receiver. Simple to install. I installed the hardware in about 10 minutes. Servo reversing is done through firmware and took some time to get the seqence down. I used my "FLAPS" channel to switch the unit. I"m able to switch between off, Normal, and 3D while in the air, from my transmitter. You can adjust the amount of assistane for each channel using the pots. I was surprised to find no servo "twitching", even at higher pot levels. You can also reset the gyros to level in the air by switching between 3D and normal quickly. I use this in a J3 Cub, as it likes to ground loop on takeoff. This keeps it straight down the runway. It also allows me to fly straight and level when the wind picks up. That adds to the number of days I can fly. For 3D, it holds the last attitude. I'm ordering 2 more to fit into other models. At this price, I can have the option of using it without having to move it from one plane to another. Time will tell about durability, but I installed and flew it in one day and, so far, I love it!
By c***t
June 25, 2017
By Tibor A Berenyi
June 21, 2017
By b***2
April 8, 2017
By m***d
January 15, 2016
By d***0
January 9, 2016
By j***l
December 23, 2015