Descriptions:1. DJI adheres to continuous innovating and improving, with the new firmware, new attitude stabilization algorithm and optimized hardware structure, the Naza-M V2 provides better flight performance.
2. The innovative All-in-one design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis gyroscope, 3-axis accelerometer and barometer in its light and small Main Controller. It can measure flying altitude, attitude and therefore can be used for autopilot/automatic controlling.
3. The latest fourth generation attitude stabilization algorithm not only inherits the outstanding flight stability of DJI products, but also provides excellent maneuverability. It is more flexible and stable, and gives the hobbyists a wonderful flight experience. New features have been added, such GPS automatic course compensation, GPS & Compass sensor calibration, new take-off mode and more.
4. Naza-M V2, with PMU V2 module with CAN BUS port, could support iOSD, GoPro gimbal, BT LED
module and so on. And Naza-M V1 is compatible with Naza-M V2 PMU as well. Please check the chart below.
The NAZA-M system communicates with other DJI products (e.g. H3-2D gimbal, BTU module, iOSD mini and iOSD Mark II) via the CAN-Bus port of the NAZA PMU V2. You can plug new DJI products into any spare CAN-Bus port, since CAN-Bus ports on NAZA-M, CAN HUB, GCU, iOSD mini and iOSD Mark II are the same for the communications. When there are not enough CAN-Bus ports for additional DJI products, then a DJI CAN HUB module is recommended. The following diagram is for your connection reference.
Used with CAN HUB
Used with iOSD Mark II
9 types Multirotor Configurations Supported
The Naza-M V2 is a powerful flight controller for enthusiast, commercial and industrial flyers. It’s easy to install, simple to configure and above all, extremely stable. Nine types of traditional motor mixes are supported, making it ideal for every setup.
The Naza-M V2 supports 9 types of traditional motor mixer:
Flight Performance:Hovering Accuracy(GPS Mode):
Vertical:±0.8m
Horizontal:±2.5m
Max Yaw Angular Velocity: 200°/s
Max Tilt Angle: 35°
Ascent / Descent: 6m/s，4.5m/s
Specifications:Working Voltage Range:
MC:4.8V~5.5V
VU Input: 7.4V ~ 26.0 V(recommend 2S ~ 6S LiPo)
Output(V-SEN port red wire): 3A@5V (burst current:7.5A)
Power Consumption:
MAX: 1.5W(0.3A@5V)
Normal:0.6W(0.12A@5V)
Supported ESC output: 400Hz refresh frequency
Recommended Transmitter: PCM or 2.4GHz with minimum 4 channels
Operating Temperature: -10°C ~ 50°C
Assistant Software System Requirement: Windows XP sp3 / Windows 7 / Windows 8
Notices: For safety reason, do not use power battery during firmware upgrade.
Package Size: 13 * 9 * 8cm / 5.1 * 3.5 * 3.1in
Package Weight: 287g / 10.1oz
Package list:1 * DJI NAZA V2 Flight Controller
1 * GPS/Compass Module
1 * GPS Holder
1 * NAZA PMU V2
1 * Remote LED
1 * USB Connector Wire
8 * Connetor Wires
