Price:
US$
20.99
Loading...
Ship to
color:
if the goods arrival in 90 days,we will inform you by email!
Error appeared,Please try again later!
Questions & Answers
To set the mode use the left stick used for throttle center it and press down 1 beep beginner 2 beep moderate 3 beep expert.
By Donald J. Kovacs Jr. on July 5, 2017
I plugged mine up to my Xbox to charge it, I think it should be fine plugged up to any USB port
By Daniel Vaughn on October 2, 2017
If they all stop it could be a dead battery. If just one it could be jammed. They can be replaced.
By Jack on May 14, 2018
I would rinse it right away so theres no coffee residue....and then let it dry. Mine flew into the aquarium and i just let it air dry and it works just fine.
By hinajm on April 17, 2018
All info is online.
By Stephen Y. Bartlett on April 14, 2018
It came with all four blades on both of ours! But we had a defective one, they sent us a new one, didn't work so they gave us a refund. Very amazing customer service. My husband even wants to buy again but you have to be super careful with them!
By Aubrey on April 5, 2018
I would say around 20-25ft before you will start to encounter connection problems.
By s on April 7, 2018
It only takes a few minutes to charge & is not designed to swap batteries. They're so cheap just get two for perpetual fun.
By J. Ashley Cooper on April 2, 2018
The following takes longer to describe than to do, and is for mode 2 (most common control set up for drones) Pairing and calibration only take 30 seconds if that. Your Drone and controller may not be paired properly. After fully charged (red light on usb cable is lit while charging, light on USB turns off indicating … see more The following takes longer to describe than to do, and is for mode 2 (most common control set up for drones) Pairing and calibration only take 30 seconds if that. Your Drone and controller may not be paired properly. After fully charged (red light on usb cable is lit while charging, light on USB turns off indicating charged.. usually 20-30 mins at most). First turn on drone, place on flat surface best to have fwd direction (blue lights) facing north/away from you and lights on drone are blinking. Then be sure the throttle stick (left) on controller is all the way down, turn on controller (it will beep twice), then move left stick all the way up (another beep) then all the way back down (another beep) .. Lights on drone go solid indicating it is paired with controller. If drone stops responding during flight.. could be interference (but is usually only monentary), could be beyond control distance about 100ft, could be batteries in controller need to be replaced. You can calibrate controller also if drone drifts and cannot be fixed by using the trim buttons. After pairing, while drone is still on flat surface press the throttle (left) stick in (press on it like a button, one beep is low, two beeps is medium, 3 beeps is advanced/fast.. put in fast mode, 3 beeps. Then put the left stick to the lower left position and the right stick to the upper left position. The drone lights will blink and then go back to solid, calibration complete. see less
By MichaelT808 on March 28, 2018
Excahnge it for another one.
By JB on March 27, 2018
Discussions
Please note that TOMTOP Forums are a community for all communicating and getting help each other. There will be some enthusiastic friends participate in your discussions. Of course TOMTOP customer service (with tomtop customer service icon) response is guaranteed ,which is the same way you contact us at http://www.tomtop.com/contacts
open this forum in full pageAverage Rating:
4.1based on 574 Customer Reviews
Share your thoughts with other customers and get Tomtop Points, the first 5 reviews get DOUBLE Tomtop Points!
Write a Customer ReviewBy Cynthia F.
October 19, 2020
By jim
July 12, 2020
By Yusra
June 7, 2020
By T D
May 19, 2020
Probably not a good starter drone but if you have at least limited experience with drone controlls its doable. The throttle is touchy and this thing has some unexpected power. Going to use it at lunch brakes at work in an industrial building my 12x17 living room is to small for me to fly.
By Harry
April 16, 2020
By TBS
December 15, 2019
By Mika Akiyama
December 15, 2019
By Adrian Curley
December 14, 2019
By Princess
December 14, 2019
By Sarai
December 14, 2019
By Lagavulin Talisker
December 14, 2019
By KB
December 13, 2019
Really fun but it broke within an hour. I had never flown a quadcopter before and crashed it a few times. Sometimes when it crashed the motors all went full speed on their own and wouldn't stop until I turned it off. This would cause it to smash into the ceiling at full speed. One bad crash caused a wire connecting one of the motors to break. I went out and bought a cheap solder and soldered it back into place and it worked again for another full charge then it lightly crashed and a different motor broke. This time it broke the wire too short and now I need to order replacement motors to fix it. Overall I enjoyed it so much I bought another one and replacement motors to fix this one. Its a great quadcopter to get started in this hobby. I would give it more stars if it didn't break so easily, I hardly got to enjoy it.
By baseball
December 13, 2019
By DaFunkt
December 13, 2019
After a few days, with normal flying (using mostly the right stick to steer since I am still learning) and some slight crashes (nothing drastic), it started to work with a defect. When applying throttle 30-50%, the quadcopter just stops. Will lift then drop. You can full throttle it to have it dart up, but after a second or two, stops again and crashes to floor. Did some research, and apparently it is kind of a common problem with this particular model (cx-10), and most claim was fixed in future models (CX-10A, CX-10C). I bought another one hoping that it was just a fluke, but the same thing happened within 3 days of receiving that one as well. So I returned it..
By Greg G
December 13, 2019
By sherrie m. mezyk
December 13, 2019
By Adam Endres
December 12, 2019
By Tilk
December 12, 2019
This was a great inexpensive way to experiment with drones for the first time. This does not self-level itself which can make it tricky. I hit MANY things in my house with this drone and was starting to get the hang of it when I hit a wall and broke a plastic piece under one prop. It wouldn't fly so I added the smallest drop of crazy glue I could, but that extra weight negated the fix I made. What can I say? It's cheaply made but it's a lot of fun. If you're on the fence about flying drones but don't want to spend major money on an unknown hobby, this is a fantastic first experience.
By Nathan Y
December 12, 2019
This would be an excellent quadcopter for a novice, though there aught to be many more replacement blades included. If you bump into anything, there's a good chance one or more blades will either break, or come loose at high speeds. Maneuverability is outstanding, and this little thing can fly *really* quick.
By lisa thiphavong
December 12, 2019